欧美极品少妇做受,freeⅹ性欧美xvideos

TranslationMobile

彈簧隔板

"spring" in Chinese : n. 1.春季，春天。 2.青春；初期。 3.〔pl.〕 ...
"insert" in Chinese : vt. 1.插進，夾入。 2.寫進，記入；刊登。 3.( ...
"spring seat insert" in Chinese : 彈簧卒墊塊
"insert" in Chinese : vt. 1.插進，夾入。 2.寫進，記入；刊登。 3.(縫紉中)鑲，補。短 ...
"insert into" in Chinese : 插入
"a spring" in Chinese : 彈簧
"at the spring" in Chinese : 在春天
"in spring" in Chinese : 在春季; 在春天
"in the spring" in Chinese : 春天里
"it is spring" in Chinese : 春天到了
"spring" in Chinese : n. 1.春季，春天。 2.青春；初期。 3.〔pl.〕大潮時期。 4.泉。 ...
"spring for" in Chinese : 請客
"this spring" in Chinese : 今年春天
"accordion insert" in Chinese : 折疊廣告
"adaptor insert" in Chinese : 插入接頭

Examples

Research on forced convection heat transfer in a horizontal tube with spiral spring inserts
螺旋線圈強化管內單相流體傳熱的研究
The heat transfer in vertical tube falling film evaporator equipped with spring inserts is investigated the first time . all kinds of influence factors are analyzed after a larger number of experiments
本文首次對安裝有彈簧插入物的豎管降膜蒸發的傳熱性能進行了實驗研究，并與光管的傳熱性能進行了比較。
Heat transfer will worsen if structure parameters of the spring inserts are not fit . the paper think that the mechanism of heat transfer enhances of the spring inserts is the laminar flow lining is thinner because of librating of the spring inserts , accordingly the part of convection is enhanced . but the part of boil is not influenced
通過彈簧插入物的各個參數對傳熱性能的影響分析，認為彈簧插入物對豎管降膜蒸發傳熱強化的機理主要是彈簧的振動加強了液膜的湍動，減薄了層流內層，從而強化了對流傳熱分量，但對沸騰傳熱分量沒有影響。
Based on the j c chen double mechanisms superposition model , the experimental formula of the heat transfer coefficient on the evaporation side in the smooth tube was obtained . considering the influence of spring to the falling film , the formula of heat transfer coefficient on the evaporation side in the vertical tube with spring inserts was obtained . the predicated heat transfer coefficient through this two formulas was finely accord with the experimental result , and the error was basically under 10 %
在jcchen雙機理加和模型的基礎上，得出了光管降膜蒸發側傳熱系數的實驗關聯式，并考慮了螺旋線對降落液膜的影響，得出了管內插入螺旋線的降膜蒸發側傳熱系數關聯式，這兩個關聯式預測的傳熱系數與實驗值吻合良好，誤差基本在10以內。
Exerting the model of two mechanism heat transfer , the formulation for heat transfer coefficient of liquid film which in smooth tube and equipped with spring inserts is given in this paper . heat transfer coefficient is presented which not only has relation to reynolds number , temperature difference , liquid characteristic , but also is greatly influenced by structure parameter of the spring inserts . experiments indicate the heat transfer coefficient of tubes equipped with spring inserts is 25 % higher than smooth tube
實驗表明，傳熱系數和液膜雷諾數、傳熱溫差、料液物性參數利彈簧插入物的結構參數有關，實驗條件下，安裝有彈簧插入物的豎管降膜蒸發液膜側的傳熱系數比光管的傳熱系數可高達25左右，但某些結構參數的彈簧插入物會造成傳熱的惡化。